D.30W Liquid Membrane Waterproofing for Floors & Walls

Liquid membrane, a single-component, solvent-free, and waterproof waterproofing membrane for subsequent ceramic floor coverings such as tiles. Ideal for wet areas. Can be applied to floors and wall surfaces indoors. The liquid membrane forms a tight and elastic floor & wall coating. Fine cracks and joints are bridged.

Product data
- Solvent-free
- Highly elastic
- High adhesion strength
- Silicone compatible
- For full-surface waterproofing
- Ideal for wet areas
- Suitable for underfloor heating
- Water-impermeable
- For walls and floors
- Very good crack bridging
- Perfect application thickness
- Viscous sealing compound
- Easy application (paint roller included)

Interesting additional products
- BEKATEQ BE-518 deep primer for absorbent substrates
- BEKATEQ BK-180 whitish adhesion primer for smooth substrates
- BEKATEQ BK-155 quartz primer ideal for smooth substrates
- BEKATEQ BK-165 concrete primer ideal for smooth substrates
- BEKATEQ BK-110EP 2K epoxy fine filler for walls and especially floor surfaces
- DICHTON D.50W 1-component ready-mixed filler for wall surfaces

Technical specifications
- Color: Gray
- Density: approx. 1.50kg/dm3
- Application: Rolling, brushing, troweling
- Number of coats: at least 2 (3 recommended)
- Material consumption: 0.4kg to 0.7kg/sqm per coat depending on the substrate
- Drying time/recoat time: after approx. 4 hrs at 20°C
- Drying of the final coat: approx. 24 hrs
- Application temperature: approx. +5°C to +30°C
- Cleaning of tools: with water
- Storage: approx. +5°C to +30°C

The drying times refer to 23°C and 50% relative humidity. Higher temperatures and lower humidity shorten the drying time, lower temperatures and higher humidity extend it.

Suitable for non-absorbent but also for absorbent substrates indoors. The product can be used on concrete, aerated concrete, gypsum and cement plaster, gypsum and gypsum fiberboard, as well as fully dried screed.

Application: Apply DICHTON liquid membrane in two coats evenly to the prepared substrate. First seal expansion joints, corners, pipe penetrations, and floor drains with special sealing tape, corners, or sleeves, and embed them in the mortar. Apply the liquid membrane to the entire surface with a paint roller, painter's brush, brush, or steel trowel and rub it intensively into the substrate. The thickness of the individual wet coats should not exceed max. 1 mm. Apply the next coat after the previous one has dried. The layer thickness of the finished coating should be at least 1 mm. Protect the freshly applied waterproofing layer from drying out too quickly and damage during further processing.

Substrate preparation: The substrate must be firm, dry, level, clean, crack-free, load-bearing, and free of all substances that could impair adhesion (such as dust, oil, loose paint residues, etc.). Substrates with underfloor heating must be sufficiently heated beforehand (gypsum substrate below 0.5 % CM, cement substrate below 2 % CM). Trowel out larger unevenness with a suitable product. Treat substrates with the corresponding BEKATEQ primer. Absorbent substrates: BEKATEQ BE-518 deep primer - non-absorbent/smooth substrates: BEKATEQ BK-180 adhesion primer or BEKATEQ BK-165 concrete primer. Allow the primer to dry completely. Do not use in areas exposed to constant contact with water and rising moisture from the substrate.